Home > News > Content
Products Categories
Contact Us

Zhejiang Jieshitai Electrical Co.,Ltd

+86-577-61310208

+8613738769258

zjxs02@cnjst.com

Puhu Industrial Zone, Shifan, Yueqing Zhejiang, China

Installation Method Of Lamp Belt
Nov 20, 2018

1, indoor installation: LED lamp belt for interior decoration, because do not have to withstand the wind and rain, so the installation is very simple. To light rainbow electronic production of LED lamp belt as an example, each LED lamp belt behind the affixed with self-adhesive 3M double-sided adhesive, installation can be directly ripped off the 3M double-sided adhesive surface of the sticker, and then the lamp bar fixed in the need to install the place, with the hand flat on the line.

If there are places to need a corner or a long range, just put the LED lamp belt in 3 LEDs as a group of serial and parallel composition, because every 3 LEDs can be cut, used alone. 

2, Outdoor Installation: Outdoor installation due to the wind and rain, if the use of 3M glue fixed, a long time will cause 3 m glue viscosity reduction and lead to the LED lamp belt off, so outdoor installation often uses the card slot fixed way, need to cut and connect the place, the method and indoor installation, but also need to be equipped with waterproof glue,To consolidate the waterproof effect of the connection point. 

3, Power connection method: LED lamp belt general voltage is DC 12V, so the need to use switching power supply, the size of the power supply according to the LED lamp belt power and connection length to set. If you do not want each LED light belt to be controlled with a power supply, you can buy a more powerful switching power supply to do the total power supply, and then all the LED lights with the input power supply all in parallel (the wire size can not be extended separately), unified by the total switching power supply.

The advantage is that it can be centrally controlled, inconvenient to show in the failure to achieve a single LED light band lighting effect and switch control, the specific method can be measured by their own. 

4, the Controller connection mode: LED running horse lamp belt and RGB full lantern belt need to use the controller to achieve the change effect, and each controller control distance is not the same. In general, the control distance of the simple controller is 10~15 meters, the control distance of the remote control controllers is 15~20 meters, the maximum can be controlled to a distance of 30 meters.

If the LED lamp belt has a long connection distance and the controller cannot control that long light band, then a power amplifier is required for the tap.

5, pay attention to the LED lamp belt connection distance: In general, 3528 series of LED light belt, its connection distance of up to 20 meters, 5050 series of LED light belt, the maximum connection distance of 15 meters. If this connection distance is exceeded, the LED light band is easy to heat up and will affect the service life of the LED lamp belt during use.

Therefore, the installation must be carried out in accordance with the manufacturer's requirements, avoid LED lights with load operation.


Related News

Copyright © Zhejiang Jieshitai Electrical Co.,Ltd All Rights Reserved.